Quick question for some reason i cant find answer.

  • Thread starter Thread starter 2lim
  • Start date Start date
2

2lim

New member
I need to build an XLR to 1/4" unbalanced..... what gets connected to where? I know where the shield wire goes, but there are 2 "signal" wires on the XLR so which one do I connect to the signal on the 1/4" unblanaced? Or do i connect both?


Simon
 
ok.. I cant get to mediacollege.com in either of my browsers! I will try again tomorrow cause my puter is know for being finicky.


Simon
 
maybe this will show up
 

Attachments

  • XLR-monojack.webp
    XLR-monojack.webp
    5.3 KB · Views: 70
I actually got the page working seconds after that post... but I never came back to post cause I wanted to get the cable built lol.
Thanks Again!!

Simon
 
You should check the pin out of the equipment you want to use that on. Most gear is pin #2 hot on an XLR but some (like my M-3500 console) is pin #3 hot.
 
You must log in or register to reply here.
Back
Top