Hi
As you can tell i am having a few feedback problems when i "link" my system up.
Firstly i am a novice, and my setup is..
PC 500mhz (intel)
Yamaha SW1000G
Beringer MX1604a (12 chans)
I have from my LR output on my SW1000G going to a STEREO LINE IN on my mixing desk. (2 x Minijack --> 2 x 1/4 Jacks)
On my mixing desk from ALT OUTPUT to the INPUT on my SW1000G (2 x 1/4 Jacks going to 1 x Stereo Minijack)
Whenever i connect all the above i get a really annoying loud "hmmmmmmm" noise which obviously stops me recording!
If i remove either end of connections (ie on the mixing desk in or the mixing desk out) the noise goes away.
So i can record to my PC if the output is disconnected, i just can't if both are connected! (the noise is far to "noisey")
Oh - from my MAIN OUTPUT on my mixing desk i have that to my monitors.
How can i get rid of that "humm"? any ideas would be great
If i have missed off any important information please don't hesitate to ask me for it!
My beringer mixing desk was a german import so it therefore uses a "2 pin plug" (no earth) - would this be causing a problem?
Thanks in advance!!
Oliver Cookson
As you can tell i am having a few feedback problems when i "link" my system up.
Firstly i am a novice, and my setup is..
PC 500mhz (intel)
Yamaha SW1000G
Beringer MX1604a (12 chans)
I have from my LR output on my SW1000G going to a STEREO LINE IN on my mixing desk. (2 x Minijack --> 2 x 1/4 Jacks)
On my mixing desk from ALT OUTPUT to the INPUT on my SW1000G (2 x 1/4 Jacks going to 1 x Stereo Minijack)
Whenever i connect all the above i get a really annoying loud "hmmmmmmm" noise which obviously stops me recording!
If i remove either end of connections (ie on the mixing desk in or the mixing desk out) the noise goes away.
So i can record to my PC if the output is disconnected, i just can't if both are connected! (the noise is far to "noisey")
Oh - from my MAIN OUTPUT on my mixing desk i have that to my monitors.
How can i get rid of that "humm"? any ideas would be great
If i have missed off any important information please don't hesitate to ask me for it!
My beringer mixing desk was a german import so it therefore uses a "2 pin plug" (no earth) - would this be causing a problem?
Thanks in advance!!
Oliver Cookson