spottydog10
Member
Hello all, nice to be here and wonder if you could help with a problem.
I have the Mackie Onyx 1620i but the firewire has been failing over the last couple of years despite changing firewire cards, cables and even the PC.
I decided to ditch the firewire connection and just use the Mackie as a mixer connected to an EMU 0404.
The issue is the cabling, I currently have it connected like this.
Control Room Out to monitors.
Emu Outs to Channel 9 in the Mackie.
Emu Ins fed by Tape out from the Mackie.
This OK to an extent (and lets me use the Control Room Volume nob which is very handy)
but if I record say, a vocal over a backing track, the backing track is bleeding thru as well (not from the mic)
Can anybody suggest a better way of wiring this combination?
Thanks a lot,
Mike
I have the Mackie Onyx 1620i but the firewire has been failing over the last couple of years despite changing firewire cards, cables and even the PC.
I decided to ditch the firewire connection and just use the Mackie as a mixer connected to an EMU 0404.
The issue is the cabling, I currently have it connected like this.
Control Room Out to monitors.
Emu Outs to Channel 9 in the Mackie.
Emu Ins fed by Tape out from the Mackie.
This OK to an extent (and lets me use the Control Room Volume nob which is very handy)
but if I record say, a vocal over a backing track, the backing track is bleeding thru as well (not from the mic)
Can anybody suggest a better way of wiring this combination?
Thanks a lot,
Mike