Looking for a MXL 2003 Rev 2 schematic or help.

6

68hodaka

New member
Do any of you folks have one you might be able to e-mail me or point me to a link?

Or, if you know where the following wires attach that would certainly help.

1. The 200M thin film resistor on the the switch board.
2. The Yellow wire that attaches from one of the long boards to the switch
board.
3. The Red wire that attaches to both top and bottom board.
4. The Blue wire that attaches to both top and bottom board.

I bought this mic used and abused and want to get it working.

Thanks in advance.
 
dgatwood said:
Post pics and we might be able to figure it out.
Click to expand...

Thanks, but I don't think taking pics would do much good.
I think I'll either need a schematic or someone with a 2003 Rev 2 and willing to open it and take some pics for me.

Thanks again.
 
68hodaka said:
Thanks, but I don't think taking pics would do much good.
I think I'll either need a schematic or someone with a 2003 Rev 2 and willing to open it and take some pics for me.

Thanks again.
Click to expand...

Without pics, the only people who could help are people with that exact model of mic.

With pics, anyone with any of the eighty different Chinese LDC mics that use the same circuit board can help. :)

Also, if you shoot the board trace side, we can probably figure out where some of the wires go just by studying the component layout even without knowing the exact schematic.
 
You must log in or register to reply here.
Back
Top