getting a C1 running?

S

stecel

New member
Ok.

So this is probably a stupid question, but I just bought a C1 and I can't get it to run. I am running it into a behringer mx602a.. Any suggestions?
 
No i don't think I do. I am pretty sure thats my problem. It says something about that in the manual, but I don't know what phantom power is and how to turn it on. hehe
 
Is the volume on the channel turned up?

Is the master volume turned up?

Have you got your headphones/monitor volume turned up?
 
stecel said:
No i don't think I do. I am pretty sure thats my problem. It says something about that in the manual, but I don't know what phantom power is and how to turn it on. hehe
Click to expand...

Its in your mixer manual....I dont know how to turn it on your particular mixer, but there should be a switch somewhere.
 
It's a good idea to always turn the phantom power OFF before you plug or un-plug your mic, just incase you did know. Also read the mic care thread.
 
You must log in or register to reply here.
Back
Top