Adat-Connect/Edit
Mac G4 733
Hi folks,
New to the forum. I searched a bit but didn't find my answer.
I have an Adat/Connect, Edit setup from years ago that worked fine. The PCR card was in my B&W Mac G3. My Adat is an XT.
Years went by and I decided to hitch it up again so I could get the tracks into my computer.
I acquired a G4 733 and decided to put the card in it instead of the G3. I downloaded "Connect" and "Edit" from Alesis and installed.
The connections to the card are a bit confusing. Does it matter which light pipe goes in which connector? The 9 pin connector (vga looking plug) also has 2 choices, not sure which one to sue either.
When I try to run "Connect" it sees the card but "sort of" sees the deck. I can change clock speeds, but the transport will not work at all. I think I have tried every plug combo, tried starting the adat up first, last, during.
I have install the software as per instructed.
Anybody remember? Or still use?
Thanks very much,
-ugmold
Mac G4 733
Hi folks,
New to the forum. I searched a bit but didn't find my answer.
I have an Adat/Connect, Edit setup from years ago that worked fine. The PCR card was in my B&W Mac G3. My Adat is an XT.
Years went by and I decided to hitch it up again so I could get the tracks into my computer.
I acquired a G4 733 and decided to put the card in it instead of the G3. I downloaded "Connect" and "Edit" from Alesis and installed.
The connections to the card are a bit confusing. Does it matter which light pipe goes in which connector? The 9 pin connector (vga looking plug) also has 2 choices, not sure which one to sue either.
When I try to run "Connect" it sees the card but "sort of" sees the deck. I can change clock speeds, but the transport will not work at all. I think I have tried every plug combo, tried starting the adat up first, last, during.
I have install the software as per instructed.
Anybody remember? Or still use?
Thanks very much,
-ugmold