Dug out my Zoom R 16, and set up so that I can successfully get a signal into Reaper, but am wondering if there is another setting that I could activate in Reaper which would enable me to be able to either monitor or print the Zoom R 16's FX when I am recording into Reaper.

The display on the R 16 continues to read '44.1 Khz', even when I try to access other menus in order to use the FX.

The Zoom R 16 website says that it is possible to use the R 16's effects when using the unit as an Audio Interface, but I cannot figure out how to do this, and the manual is not forthcoming about this, either.

I would appreciate any help that anyone can give me with this.

Thanks.