Audiofan111
New member
Hi,
I purchased a Tascam M320B used a few months back. I have hooked up a Shure mic to an XLR port with no problems and sounds good. However, I am trying to hook up just a cd player to the mixing console. It would appear that I am getting a two-channel mono sound. A specific song tipped me off to this because some of the vocals are missing. I think I have tried every possible angle at hooking it up, using a 1/4 jacks and rca plugs in but apparently not. The complexity of the board is new to me and quite overwhelming, but I know it is still a nice piece of equipment. Perhaps there is something wrong internally. I'd appreciate it if somebody could help me out steer me in the right direction. Secondarily, I have an DBX 266 compressor I'm trying to hook up properly. I'd appreciate any help there as well.
Thanks
Audiofan111
I purchased a Tascam M320B used a few months back. I have hooked up a Shure mic to an XLR port with no problems and sounds good. However, I am trying to hook up just a cd player to the mixing console. It would appear that I am getting a two-channel mono sound. A specific song tipped me off to this because some of the vocals are missing. I think I have tried every possible angle at hooking it up, using a 1/4 jacks and rca plugs in but apparently not. The complexity of the board is new to me and quite overwhelming, but I know it is still a nice piece of equipment. Perhaps there is something wrong internally. I'd appreciate it if somebody could help me out steer me in the right direction. Secondarily, I have an DBX 266 compressor I'm trying to hook up properly. I'd appreciate any help there as well.
Thanks
Audiofan111
Last edited: