dustybowldays
New member
disc low leveled formatted and initialized
projected created
auto input on mode
project in TL-Tape Mode
tape start at 1 hour
tape length 10 min
track level meter on track 1
sound from mixing board is visible on track meter
record/select button engaged
i press the track meter button again on track one - the red record ready indicator blinks
i hit hold the play button down for a couple of second ..... the hit the record button
the red indicator light on channel stops blinking and stays red as does the light below the record button
i hit stop button after recording 20 seconds or so ......... then double hit rewind to go back to beginning.
i hit play and ???? ...... no visible audio on track meter ....... no audio playing back through mixer ??
i am using a mic into mixer input for recording ...... then using same input for the mx2424 playback.
My thinking is that i should see recorded audio on the track 1 meter after recording upon playback whether
it goes back into the mixer or not.
stumped i am !!!
dusty bowl
projected created
auto input on mode
project in TL-Tape Mode
tape start at 1 hour
tape length 10 min
track level meter on track 1
sound from mixing board is visible on track meter
record/select button engaged
i press the track meter button again on track one - the red record ready indicator blinks
i hit hold the play button down for a couple of second ..... the hit the record button
the red indicator light on channel stops blinking and stays red as does the light below the record button
i hit stop button after recording 20 seconds or so ......... then double hit rewind to go back to beginning.
i hit play and ???? ...... no visible audio on track meter ....... no audio playing back through mixer ??
i am using a mic into mixer input for recording ...... then using same input for the mx2424 playback.
My thinking is that i should see recorded audio on the track 1 meter after recording upon playback whether
it goes back into the mixer or not.
stumped i am !!!
dusty bowl