skywaveTDR
Active member
To keep things alive around here I thought I would ask if anyone had a 450 or A450 with the speed being too high by 60-70 Hz while using the smaller 60Hz pulley section and the correct and even a new 3uFd motor run caps and the motor was replaced by the one I sold him that was new Teac stock. I oiled it before it was sent out with AMSoil which I have used in the decks of all kinds for the last 3-4 years now. Never had I seen a deck go over speed with that oil. Torques are normal too the belt looks new.
If someone had resolved this problem I would like to know what their solution was. I already know what my solution came out to be but I am wondering if I missed something.
Also the voltage and wiring of the motor to the terminal strips are the same as a untouched from the factory unit I own.
Even theories will be welcome.
If someone had resolved this problem I would like to know what their solution was. I already know what my solution came out to be but I am wondering if I missed something.
Also the voltage and wiring of the motor to the terminal strips are the same as a untouched from the factory unit I own.
Even theories will be welcome.