Cubase5, I get only noise from audio channels...

Leandrusi

New member
While I was trying to record from my condenser mic thru scarlett 2i4 I was only getting noise after normalize.
So I checked the wires, the power plugs, config....with no results, so I decided to try and hit record without anything pluged to the INS, and I STILL GET NOISE.
Maybe you guys can help me with this one? whats going on?? THANKS IN ADVANCED!
 
If you were only getting noise after normalization then you were only getting noise before normalization. In other words, the signal isn't getting from the mic to the software. The question is, is the signal getting from the mic to the interface but not from the interface to the software? Or is the signal not even getting to the interface? The lit rings around the gain controls on the interface should indicate if it's getting signal. If so, it's probably a software routing issue.
 
Back
Top