Adding VSTi effect to channel causes Reaper to exit.

[diggy_dude]

No error message, no nothing. The Nicfit nf_chords control panel appears for a second, then Reaper just poofs. This issue was posted on the Reaper support forums nearly four years ago but has apparently never been addressed.

 

[d.bop]

What VSTi are you trying to load?

I've been using REAPER for two years and have never had a problem like that.

 

[loveofjazz]

+1 Same here.
What VSTi are you loading? I haven't had problems with VSTi's...other than dreading the ReWire procedure for Reason.

 

[diggy_dude]

Nicfit nf_chords

Apparently this happens with other Nicfit VSTis too, when their control panel is floated. But the panel automatically floats when I add it to the channel. Any way to prevent that?

 

[loveofjazz]

Hmmm. Haven't seen that before. Not familiar with this VSTi, either.
Did you try posting this over on the Reaper Forum? Those guys can be extremely helpful.

 

[diggy_dude]

It was posted there almost 4 years ago and no one has offered a solution.

I feel like I keep repeating myself in this thread, so never mind.