A1A2
New member
is it just me that it takes up alot of time to switch back and forth between the snap properties?
say, I am trimming a loop, I set the snap to be 1/32 measure, trim it, and then I gotta zoom out to find the other loop I wanna connect to, then switch the snap property to 'snap to clip boundry' (cuz sometimes Sonar just doesn't do that "click"),
then I gotta zoom back in to make sure everything was connected properly.
I mean, everything works, but just takes up so much time!! Can't Sonar work like ACID where everything falls into a grid?? So I don't have to switch the snap property just to trim the loop cuz it doesn't snap at the end of each loop
Al
say, I am trimming a loop, I set the snap to be 1/32 measure, trim it, and then I gotta zoom out to find the other loop I wanna connect to, then switch the snap property to 'snap to clip boundry' (cuz sometimes Sonar just doesn't do that "click"),
then I gotta zoom back in to make sure everything was connected properly.
I mean, everything works, but just takes up so much time!! Can't Sonar work like ACID where everything falls into a grid?? So I don't have to switch the snap property just to trim the loop cuz it doesn't snap at the end of each loop
Al