In my studio, I have 4 seperate quarter inch, balanced ( stereo), tie lines running parallel throughout all rooms. These work great for sending headphone monitor mixes etc. Each room has a 4 input panel ( 1/4 inch balanced ) and all rooms are tied together in parallel. When I plug a guitar into the panel in lets say room A and bring it back out in Room B, and then into the amplifier in room B
there is a significant change in the signal, ( lower volume and less bright ). I would like to match the signal so it is as if I just plugged directly into the guitar amp. I have tried the following with no success.
1. balanced cable out of panel in room B into amp
2. regular shielded guitar cable out of panel in room B into amp
3. balanced cable out of panel in room B, into direct box , out of direct box
XLR into amp using high to low matching transformmer
4. same as above except using regular shielded guitar cable
Any suggestions on how to make this work would be appreciated
Dr Shock
there is a significant change in the signal, ( lower volume and less bright ). I would like to match the signal so it is as if I just plugged directly into the guitar amp. I have tried the following with no success.
1. balanced cable out of panel in room B into amp
2. regular shielded guitar cable out of panel in room B into amp
3. balanced cable out of panel in room B, into direct box , out of direct box
XLR into amp using high to low matching transformmer
4. same as above except using regular shielded guitar cable
Any suggestions on how to make this work would be appreciated
Dr Shock