Monitor Speaker Problem

Jim Neal

New member
I have an M-Audio Project i/o and am using outputs 1 (L) and 2 (R) to my powered Behringer monitor speakers. I get no sound from them. The speakers are functional (have tested them). Is there something that I need to do in Pro Tools 9 to make this work? My headphone signal is fine. I would like to monitor recording with headphones and then playback with monitor speakers for review. Any ideas?
 
Launch ProTools.
Go to Setup>Playback engine.

Is your interface selected?

If so, close out and proceed to Setup>I.O.
Go to the output tab, select all paths, hit delete, then if it's all clear hit default.

That should set up the proper default outputs on any new tracks.
 
Back
Top