Hello
So I've been trying to figure out why my Soundcraft EPM6 isn't being recognized by my computer. I followed a youtube tutorial on how to hook up a mixer via rca, which lead to me getting an error along the lines of "Not enough ASIO output channels available." Not knowing what that was about, I began getting pretty frustrated, but then realized what was most likely causing the problem. I somehow or another uninstalled the drivers or something for my scarlett interface, which was working prior, and I got the same error when trying to use it in fl studio 20. Upon reinstalling the drivers, my scarlett went back to working normally. So basically I think I've troubleshot it down to my EPM6 just isn't being detected by my computer even with the official drivers from the Soundcraft website. It still knows something is being plugged in, because I get prompted to choose if it's a line in, headphones, etc. I choose "line in" because that's what the tutorial said to do. I've also uninstalled and reinstalled the drivers many times, but again, I'm getting that error I mentioned earlier.
So basically to sum it up, my Soundcraft EPM6 isn't being recognized in fl studio 20, and I'm at a loss to why. Even with the official multi channel soundcraft drivers or whatever, it keeps giving me the error message.
Thankyou in advance to anyone who chips in any advice on what to do to fix this.
Best Regards,
-Dusibud.
So I've been trying to figure out why my Soundcraft EPM6 isn't being recognized by my computer. I followed a youtube tutorial on how to hook up a mixer via rca, which lead to me getting an error along the lines of "Not enough ASIO output channels available." Not knowing what that was about, I began getting pretty frustrated, but then realized what was most likely causing the problem. I somehow or another uninstalled the drivers or something for my scarlett interface, which was working prior, and I got the same error when trying to use it in fl studio 20. Upon reinstalling the drivers, my scarlett went back to working normally. So basically I think I've troubleshot it down to my EPM6 just isn't being detected by my computer even with the official drivers from the Soundcraft website. It still knows something is being plugged in, because I get prompted to choose if it's a line in, headphones, etc. I choose "line in" because that's what the tutorial said to do. I've also uninstalled and reinstalled the drivers many times, but again, I'm getting that error I mentioned earlier.
So basically to sum it up, my Soundcraft EPM6 isn't being recognized in fl studio 20, and I'm at a loss to why. Even with the official multi channel soundcraft drivers or whatever, it keeps giving me the error message.
Thankyou in advance to anyone who chips in any advice on what to do to fix this.
Best Regards,
-Dusibud.