Abominable ID
New member
Hey all,
Just thought I would ask on the off chance somebody knows about this. It involves the pots on this mixer. I would like to spray De-Oxit inside them to clean up. I tried looking for a little hole to spray in and I could not find one and they seem completely sealed. They are ALPS brand made in Japan. Then I looked at the shaft underneath the actual knob and I see a hole that seems to go down into the pot. Is it possible that this is where I should spray De-Oxit for cleaning? There is definitely some sort of grease leaking out of some of the pots around the base of the shaft, as if someone added it at some point.
If this is not the right hole, does anyone know how to clean the pots on this board? Do I have to remove the faceplate? Some of them are pretty bad...thanks in advance!
-Ash
Just thought I would ask on the off chance somebody knows about this. It involves the pots on this mixer. I would like to spray De-Oxit inside them to clean up. I tried looking for a little hole to spray in and I could not find one and they seem completely sealed. They are ALPS brand made in Japan. Then I looked at the shaft underneath the actual knob and I see a hole that seems to go down into the pot. Is it possible that this is where I should spray De-Oxit for cleaning? There is definitely some sort of grease leaking out of some of the pots around the base of the shaft, as if someone added it at some point.
If this is not the right hole, does anyone know how to clean the pots on this board? Do I have to remove the faceplate? Some of them are pretty bad...thanks in advance!
-Ash