Cool username
New member
Hi! Long time lurker here.
Recently got into analog recording as well an it is a lot of fun. Other threads in this forum helped me fix my Tascam 38. Unfortunately I ran into a problem with my mixing desk today. I hooked a compressor up to the master Insert and after I was done with it, I unplugged it but now on the master channel the ride side is cutting out. It works if a louder signal is coming through it but after a while cuts out again.
Not talking about the output, because also the LEDs go out when the signal cuts out.
I received the console well maintained. No faders or potis scratch. It just sat in a living room, wrapped in plastic foil for a while before I got it.
Maybe you guys have some suggestions cause I wanna know my options before I tear the whole console apart.
Thanks.
Recently got into analog recording as well an it is a lot of fun. Other threads in this forum helped me fix my Tascam 38. Unfortunately I ran into a problem with my mixing desk today. I hooked a compressor up to the master Insert and after I was done with it, I unplugged it but now on the master channel the ride side is cutting out. It works if a louder signal is coming through it but after a while cuts out again.
Not talking about the output, because also the LEDs go out when the signal cuts out.
I received the console well maintained. No faders or potis scratch. It just sat in a living room, wrapped in plastic foil for a while before I got it.
Maybe you guys have some suggestions cause I wanna know my options before I tear the whole console apart.
Thanks.