Record LED problem

[RandyRhoads1981]

So, I had my MS-16 Meter Panel disassembled
and I knocked the Ch-16 Meter pot a tiny bit, and
then the REC LED just kicked on and didn't turn off.
I then removed it and reseated the LED and
also swapped it with another lamp.
The Lamps are fine.
It stayed off constantly now.
So I reversed it again, and the
light stayed on constantly.

So, perhaps one of the
solder holes is not functioning
properly? Because it's either
completely off or completely on.
Switching into Record mode
does not change anything.

Any ideas?

 

[The Ghost of FM]

You might need to change the trim pot if you damaged it when you bumped it.

Hard to say though with seeing the board.

Cheers!

 

[RandyRhoads1981]

You might need to change the trim pot if you damaged it when you bumped it.

Hard to say though with seeing the board.

Cheers!

Thanks for the reply.
I'll take a pic of the PCB.
Which trim pot are you speaking of?
It was the Meter itself that I bumped.

Should I try re-soldering the wires
that connect to the Meter and/or PCB?
It seems strange that I lightly bumped
the Meter and the Rec LED came on.
They are two different things and areas.

 

[sweetbeats]

It seems strange that I lightly bumped
the Meter and the Rec LED came on...

Hey, man...we are ALL afraid of things that go bump in the night in one way or the other...

 

[The Ghost of FM]

I knocked the Ch-16 Meter pot a tiny bit, and
then the REC LED just kicked on and didn't turn off.

Any ideas?

You might need to change the trim pot if you damaged it when you bumped it.

Hard to say though with seeing the board.

Cheers!

Which trim pot are you speaking of?

The one you said you knocked!

Cheers!