RandyRhoads1981
New member
So, I had my MS-16 Meter Panel disassembled
and I knocked the Ch-16 Meter pot a tiny bit, and
then the REC LED just kicked on and didn't turn off.
I then removed it and reseated the LED and
also swapped it with another lamp.
The Lamps are fine.
It stayed off constantly now.
So I reversed it again, and the
light stayed on constantly.
So, perhaps one of the
solder holes is not functioning
properly? Because it's either
completely off or completely on.
Switching into Record mode
does not change anything.
Any ideas?
and I knocked the Ch-16 Meter pot a tiny bit, and
then the REC LED just kicked on and didn't turn off.
I then removed it and reseated the LED and
also swapped it with another lamp.
The Lamps are fine.
It stayed off constantly now.
So I reversed it again, and the
light stayed on constantly.
So, perhaps one of the
solder holes is not functioning
properly? Because it's either
completely off or completely on.
Switching into Record mode
does not change anything.
Any ideas?