SteveM
New member
I was hoping someone could clarify this term "cut track". This is the modification that was done on my soundcraft, and I want to bring it back to +4. Looking at R11 there doesn't seem to be any modification, I did find the two resistors installed though and am going to remove them. So does anyone know what they mean by "cut track"?
Here's what it says to make it -10:
The following modification should be made to each output:
1) Cut track across rear of R11
2) Add resistor in position of RX1
3) Add resistor in position of RXZ ("Z" I think they meant "2")
I think it's possible R11 was never touched and they just added the resistors.
Here's what it says to make it -10:
The following modification should be made to each output:
1) Cut track across rear of R11
2) Add resistor in position of RX1
3) Add resistor in position of RXZ ("Z" I think they meant "2")
I think it's possible R11 was never touched and they just added the resistors.