fat_fleet
Swollen Member
Hi there. I have a Tascam M-2524 mixer which is coupled with a TSR-8 1/2" deck. Up to now, I've been tracking in Reaper using an audio interface (MOTU 8pre).
Switching from the Tascam to the MOTU and back requires plugging and unplugging a whole buncha XLRs. I would like to keep them both set up at all times, but this would require either going into the board and running direct outs into the MOTU, or the other way around. Neither the MOTU nor the Tascam appear to have a direct out.. Is there a way to do this I'm not thinking of?
This also seems like it could be a viable option:
2 m 6 ft foot XLR FEMALE to dual MALE Y SPLITTER mic microphone cable auido cord 817375013425 | eBay
Are there any drawbacks to using a splitter like this? Reduced sound quality, etc? Thanks in advance.
Switching from the Tascam to the MOTU and back requires plugging and unplugging a whole buncha XLRs. I would like to keep them both set up at all times, but this would require either going into the board and running direct outs into the MOTU, or the other way around. Neither the MOTU nor the Tascam appear to have a direct out.. Is there a way to do this I'm not thinking of?
This also seems like it could be a viable option:
2 m 6 ft foot XLR FEMALE to dual MALE Y SPLITTER mic microphone cable auido cord 817375013425 | eBay
Are there any drawbacks to using a splitter like this? Reduced sound quality, etc? Thanks in advance.