Blue Jinn
Rider of the ARPocalypse
Hello,
Quick question,
Looking over the calibration procedures, (Tascam 38)it say to connect a 50kΩ load. the block diagram has a signal generator - attenuator -(which I don't see the need for using the tone generators on the boards output a nominal -10dB signal) AC voltmeter - amp - speaker.
I have a M520 board and a MOdel 5 board. The latter has a 400kHz tone, and the former a choice of 40, 1k and 10kHz. The former's tape inputs indicate a 47kΩ impedance, the latter "Greater than 50kΩ" I'm going to assume using either board as "the load" (and hearing the tone) is going to suffice. Any disagreement there?
Quick question,
Looking over the calibration procedures, (Tascam 38)it say to connect a 50kΩ load. the block diagram has a signal generator - attenuator -(which I don't see the need for using the tone generators on the boards output a nominal -10dB signal) AC voltmeter - amp - speaker.
I have a M520 board and a MOdel 5 board. The latter has a 400kHz tone, and the former a choice of 40, 1k and 10kHz. The former's tape inputs indicate a 47kΩ impedance, the latter "Greater than 50kΩ" I'm going to assume using either board as "the load" (and hearing the tone) is going to suffice. Any disagreement there?
