Hey guys, so i have the Tascam US-122 box. I finally got the workaround drivers and everything installed so this isn't a driver or software problem i don't think.
my box was recording both L and R sides for my microphone and amp cables, however all of a sudden it stopped working entirely, after much effort reinstalling my drivers and such to see if that was it, i found out my R side recorded line and mic, however my left side does not no matter what i change in the settings. if i make a loud sound while it's plugged in, it will make a blip, so i can see it can almost pick something up. So i'm wondering if something on the inside of the box went out on me like the circuit board (or whatever magic is happening in there) Any ideas? i've tried switching every switch and adjusting every nob, i honestly think it may be hardware but need some advice, even from a sound or electronics guy. Thanks in advance!
my box was recording both L and R sides for my microphone and amp cables, however all of a sudden it stopped working entirely, after much effort reinstalling my drivers and such to see if that was it, i found out my R side recorded line and mic, however my left side does not no matter what i change in the settings. if i make a loud sound while it's plugged in, it will make a blip, so i can see it can almost pick something up. So i'm wondering if something on the inside of the box went out on me like the circuit board (or whatever magic is happening in there) Any ideas? i've tried switching every switch and adjusting every nob, i honestly think it may be hardware but need some advice, even from a sound or electronics guy. Thanks in advance!