DanTascam24
Member
Hi Alan.. Hope all is good.. So I'm looking at getting my SPDIF from my audio interface (Scarlett 6i6) to my MX2424.
A little baffled, however, because, as far as I can tell, I have all MX menu parameters set properly.
And, in fact, I AM getting steady illumination of the sample lock indicator on the MX. And when I remove the cable, that light starts to blink, just as it should.
But I can't get a signal at the meters(!?)
My source is my Windows computer, a WAV file download which is audible and clear at the headphone output on the Scarlett interface.
I wonder, is it not getting to the meters, BECAUSE it is a WAV file(?)
I can't quite understand how sample lock can be good, but no audio is getting to the meters.
MX Version: 3.10
Current menu settings, as directed in manual:
002: Sample Ref: 2 Ch In
402: Inputs 17-24: 2 Ch In (17-24)
461: 2 Ch In Rate Conv: ON
462: 2 Ch In Source: SPDIF
My manual is a couple of versions older than 3.10, but seems like the above settings should create success..
Can you see what I am doing wrong?
I think maybe it could be the cable, it's a video coax cable, but I wonder, why would I get proper sample lock, if the cable was insufficient?
Any help? Thanks so much, Dan
A little baffled, however, because, as far as I can tell, I have all MX menu parameters set properly.
And, in fact, I AM getting steady illumination of the sample lock indicator on the MX. And when I remove the cable, that light starts to blink, just as it should.
But I can't get a signal at the meters(!?)
My source is my Windows computer, a WAV file download which is audible and clear at the headphone output on the Scarlett interface.
I wonder, is it not getting to the meters, BECAUSE it is a WAV file(?)
I can't quite understand how sample lock can be good, but no audio is getting to the meters.
MX Version: 3.10
Current menu settings, as directed in manual:
002: Sample Ref: 2 Ch In
402: Inputs 17-24: 2 Ch In (17-24)
461: 2 Ch In Rate Conv: ON
462: 2 Ch In Source: SPDIF
My manual is a couple of versions older than 3.10, but seems like the above settings should create success..
Can you see what I am doing wrong?
I think maybe it could be the cable, it's a video coax cable, but I wonder, why would I get proper sample lock, if the cable was insufficient?
Any help? Thanks so much, Dan