No problem with MX2424 with no remote. With remote hooked up the oscillation is quite audible and beats in time with the blinking record status lights. When recording, it's steady. The more channels placed in record, the louder it all gets. It doesn't seem to print but it is really annoying. Is this normal?
Oscillation When Using RC2424 Remote
- Thread starter RRuskin
- Start date
witzendoz
Senior Member
Is the remote power supply the original or after market? The was also a earthing problem on some early remotes, but this does not seem to be the problem they had, I have had problems with noise due to an earth loop between my external drive tower and the mx with drive noise in the audio out, but again it seems a different problem.
Try connecting a wire between the mx chassis and the mx remote case and see if the noise changes.
Is the remote cable the original cable?
Cheers
Alan
Try connecting a wire between the mx chassis and the mx remote case and see if the noise changes.
Is the remote cable the original cable?
Cheers
Alan