Hi Forum!
Two Weeks ago I bought a Tascam M50 Mixer on Ebay for 100€.
All Light,VU Meters, Channels, Peak LED do work...
No humming, just a little Fader and Pot crackling at the first but with some movement they where quiet... Nice I think!
Now the Problem:
I went trought the Maintance Procedure and found out that on my direct out / pre out and access sent the Level is way to low, when i'm using the Line / Phono or Tape inputs. With Mic input it's just a little to low... I need to turn the Trim knob up to 3 o'clock (should be 2.30 o'clock).
So my Question is: Where to start looking for the Fault? Re-cap the PSU? checking Opamp Voltages? replacing Opamps? Cleaning the Pot's?
Plz Help!!!!
Greetz from Germany.
Jazzyseb
Two Weeks ago I bought a Tascam M50 Mixer on Ebay for 100€.
All Light,VU Meters, Channels, Peak LED do work...
No humming, just a little Fader and Pot crackling at the first but with some movement they where quiet... Nice I think!
Now the Problem:
I went trought the Maintance Procedure and found out that on my direct out / pre out and access sent the Level is way to low, when i'm using the Line / Phono or Tape inputs. With Mic input it's just a little to low... I need to turn the Trim knob up to 3 o'clock (should be 2.30 o'clock).
So my Question is: Where to start looking for the Fault? Re-cap the PSU? checking Opamp Voltages? replacing Opamps? Cleaning the Pot's?
Plz Help!!!!
Greetz from Germany.
Jazzyseb