Lexicon Omega Not showing any mike inputs

Treetop

New member
This is an older box, but it has always worked. I plug into mike input 1 and get no lights to show a signal.. I tried channel two as well. Different cable and mike too. Is there some switch or button somewhere that could cause this? THANKS.
 
This is an older box, but it has always worked. I plug into mike input 1 and get no lights to show a signal.. I tried channel two as well. Different cable and mike too. Is there some switch or button somewhere that could cause this? THANKS.

If you are using a condenser mic then yes, the button marked +48v on the back would be the problem.

It's been a decade since I had one but if I recall correctly you also have to assign the mic channels using the USB button on the front as well.

Also the meter button would matter as well because it would have to correlate to the channels you are using.

Good luck.
 
Back
Top