I turned off the clock out on the sr-16 and the clock in on. I turned the midi thru off. I set PT and the sr-16 to the same bpm. In setup peripherals, MTC reader port is set to any, and generator port is set to none although I have tried setting both of those to the sr-16 with no defference. I have tried MMC both enabled and disabled as both slave and master with no defference. Midi beat clock is enabled with the sr-16 selected. With "wait for note" enabled on the transport, pressing play on the sr-16 will start PT recording. However, the sr-16 still will not follow the click. With Input quantize selected under event operations, PT will record the sr-16 correctly for several bars, eventually finding its way off again. I'm about to give up on this. Hours are passing by fooling with this nonsense LOL.
K2000 for example.
1. Set MBC only to the port that feeds the "MIDI IN" on the SR16.
(Should be out of your midi interface to MIDI IN on the SR)
2. Set the desired tempo in PT
3. On SR set "CLOCK IN" to on.
4. Press ply in PT.
U don't need to deal with MMC or MTC as you SR does not use those protocols and they only add to the confusion.
Your SR should play at the tempo that u set in PT. This is a basic MBC setup and should get u going.
Ok, I know it's been covered before, and I've even helped people to solve the problem, but I've been in the studio for 14hrs today and just can't think my way through this one. Serious case of being totally brain dead. So, here's what happened. Normally recording session, done at 44.1kHz. Mid way through, I have to open a session file at 48k. Not a problem - switch the master clock to 48, proceed as normal.
You can find clock in China.
There are currently 1 users browsing this thread. (0 members and 1 guests)