Hi all
I'm new to posting on this forum but have been tracking it for quite a while and finally need a bit of help as I'm a relative novice to home recording.
I have recently been given a MW10C as a present and it ships with Cubase AI 5.1. I normally use Sony Acid Pro so having tried with Cubase I have also then tried with Acid. I haven't set up the multi track recording with Acid before but looked up input busses and went through set up for that.
I have linked the mixer to the computer OK. I am using a spare notebook with windows xp and a built in Realtec sound card to keep the set up discrete from work notebooks etc.
I want to set up multi track recording so that I can record a local band with each port on the mixer mapping to a Audio Track in Acid. i.e. guitar 1, mike 1, guitar 2 etc simultaneously. I have set up the default devices to the USB Audio Codec in Control Panel (See attached) but I can't seem to see anything other than the MS Sound Mapper in the Preferences -> Audio Setup dialog.
When I try to map input buses to ports from the mixer I only see MS Sound Mapper.
I have set up one input bus and plugged the guitar into input 1 and managed to record from this input OK. I've then done the same for a second input individually.
I am wondering is I need other hardware (maybe a better sound card) to be able to map all tracks to inputs from the mixer.
I'd appreciate any advice you all could give. Thanks guys
I'm new to posting on this forum but have been tracking it for quite a while and finally need a bit of help as I'm a relative novice to home recording.
I have recently been given a MW10C as a present and it ships with Cubase AI 5.1. I normally use Sony Acid Pro so having tried with Cubase I have also then tried with Acid. I haven't set up the multi track recording with Acid before but looked up input busses and went through set up for that.
I have linked the mixer to the computer OK. I am using a spare notebook with windows xp and a built in Realtec sound card to keep the set up discrete from work notebooks etc.
I want to set up multi track recording so that I can record a local band with each port on the mixer mapping to a Audio Track in Acid. i.e. guitar 1, mike 1, guitar 2 etc simultaneously. I have set up the default devices to the USB Audio Codec in Control Panel (See attached) but I can't seem to see anything other than the MS Sound Mapper in the Preferences -> Audio Setup dialog.
When I try to map input buses to ports from the mixer I only see MS Sound Mapper.
I have set up one input bus and plugged the guitar into input 1 and managed to record from this input OK. I've then done the same for a second input individually.
I am wondering is I need other hardware (maybe a better sound card) to be able to map all tracks to inputs from the mixer.
I'd appreciate any advice you all could give. Thanks guys