Hi, I've been doing some mods on a pair of these mics, and everything has been fine up until now. However, because of the way i had to squeeze one of the new larger capacitors in, it was putting pressure on two of the resistors (R6 and R9) which eventually snapped off. I tried to solder them back on but the connections weren't long enough so I'm going to have to replace them. I just wanted to check if it matters what type of resistor I use for this. I know they are 200M and 51M ohm respectively, but I don't know what wattage or material they should be. Any help would be greatly appreciated, thanks.
