CEP2 and Delta 1010 playback

[Chris Fallen]

My mind is nice and boggled, so I decided to come in here and ask around.

I'm trying listen to four tracks in CEP 2.0 and send those track out my Delta 1010 outs 1-4 to go line in to my mixer 1-4. When I do this, only a stereo mix is coming out in tracks 1 and 2. What do I have to do to get CEP to send out the tracks I'm listening to track by track instead of as a mix?

[Tukkis]

I dont think you can have seperate outs for each track.

The only way to do it would be to pan track 1 hard left. Track 2 hard right and so on. Then select outputs 1/2 to tracks 1/2 and 3/4 to outputs 3/4.

Tukkis

[Chris Fallen]

So there's no way to put like, track 1 of CEP out of the Delta 1010's HW out 1 and then track 2 of CEP out the delta 1010's HW out 2? And so on?

[Tukkis]

Why do you want seperate outs anyway??

[Chris Fallen]

So I can patch it back to my m12 to monitor it easier.

[Chrisjob]

Click on the Out 1 above the button where you select the input for recording....if your soundcard allows your stereo pairs to be separated, I think it should work

[LemonTree]

sounds like you've got output 1 (channels 1&2) on the delta set as monitor mix. You can change it in the patchbay router in the control panel for the delta card.

[AudioMaverick]

First, set the track outputs in the M-Audio Control Panel. Then, Go into Cool Edit's Multitrack mode and set the outputs, there.