I just reinstalled CEP but am gettting no input level now

dialtone · #1 06-29-2007

I am using the Line 6 gear box and getting a level there, but I can't seem to find out how to point that to CEP. I check Device properties and order and they seem correct. Line 6 is selected in both Wave In and Out. Any ideas?

StackableMusic · #2 06-29-2007

Maybe a silly question, but is it just that you forgot to right-click and enable "monitor record level" on the meter?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
volume attenuator? -10dbV consumer level signal to a +4dbu input ASP8's	Goldenvoice388	Analog Only	14	12-03-2006 15:20
Line Level input on M-Audio FireWire 410 Help	Flet	Other Equipment and Reviews	2	06-07-2006 03:34
Input level "noise" of -72dbfs?	iboersma	Newbies	15	02-09-2005 22:23
ART Tube MP Input Level	Raj	Microphones	12	02-28-2000 09:16
Auto Gain on AWE64 Value at low input level	Eben van der Merwe	Digital Recording & Computers	1	09-10-1999 00:27

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)