px1000 jumper cuts

jho1986 · #1 06-28-2006

i just got a px1000 patchbay and i need each module to work so that if both rear holes are plugged into, then they dont connect. There is no configuration that works like this for these modules, so i need to cut some jumpers. Can anyone explain to me how to do this?

Thanks for any help in advance!!

xistenz · #2 06-29-2006

you can set the px1000 to be "open" or "de-normalled", which sounds like what you're talking about.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Rode NT1a Cuts out When to Close????	hottsauce_21	Microphones	1	10-15-2004 07:12
VF16 Cuts out During Monitoring	blewispunk	Fostex Forum	6	04-11-2003 09:44

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)