|
| |
|
#1
03-29-2005
|
|||
|
|||
|
custom-length cables
My studio is looking too cluttered with cables largely because they are too long. I would like to make some that are just the perfect length rather than the 20-footers I have been using. These will all be the 1/4 inch TS/TRS type. I need to make cables for the following:
Source Destination Length (ft) Channels Maudio DMP3 Yamaha MG10/2 2 2 Yamaha MG10/2 TCElectronics M300 3 2 Yamaha MG10/2 Behringer HA4700 4 2 Balanced or unbalanced? - the components say they can take either What gauge wire should be used? Stranded or solid-core? Any recommendations on the terminations? thanks, Sathyan 
|
|
#2
03-29-2005
|
||||
|
||||
|
Sathyan,
Go with the balanced and stranded core. Something like this http://www.redco.com/mogami_balanced_cable.asp The 2549 is probably most suitable. Redco has a pretty good selection of connectors too.
__________________
I wish my lawn was Emo so it'd cut itself.
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| gonna buy a bulk of cables...one short question | earworm | The Rack | 10 | 09-23-2004 17:07 |
| Advice on Stands and Cables | JGEllis | Newbies | 5 | 07-11-2004 11:22 |
| Round cables... | whattaguy | Digital Recording & Computers | 1 | 03-02-2003 22:31 |
| Need help choosing cables | Keyz316 | Other Equipment and Reviews | 8 | 02-25-2003 10:55 |
| Speaker Cables for Monitors... | Gargamel | Recording Techniques | 5 | 11-22-2001 08:59 |
![10/30 - [video] Demo Roland TD-20SX](http://en.audiofanzine.com/img/videos/audiofanet_en/sm_th/
/
/
<a target= "10/30 - [video] Demo Roland TD-20SX")
Linear Mode
