Recent content by rswils

Thanks I'll look at that as well. Much appreciated!

Thanks so much for the info, very helpful!!!

I'm micing a kick drum. I have an internal and using a the 4040 for the lows on the outside. It's about 4" from the resonant head and not overloading now. The channel volume is pretty low though it's on 1 but I'm getting good level

Thank you for the info. I actually have the AT4040. It was "pads" wasn't enabled on the Focusrite. I appreciate the response. The channel I had the mic plugged into previously didn't have a pads option

Hey....That was it!!! Thank you so much. I know it's pretty trivial for you but you helped me immensely. Much appreciated!!

Yes there is. It looks like on the 18i20 there's one for channels 1 and 2 only. On the OctoPre it's got one for every channel.

Sorry, I left out that the levels are peaking, so it's outputting signal, just too much and I can't lower the input level. Thanks again

Yes I have phantom power on.

Hello, I may have I'll check. Thank you!

Hello, I'm using Cubase and Focusrite modules and can't seem to adjust the input levels on a condenser mic. All other cardioid mics are fine, it's just the condenser that behaves like this. Does anyone have any suggestions or know what I seem to be doing wrong? I suspect it's a setting maybe...

Hello, I use Cubase 5 and would like to know the proper way of using plugins such as Guitar Rig, DrumAgog and even the built in effects, compressors etc. When I'm mixing a tune I use the effect or plugin for the selected track, then do the same for all other tracks that need effects etc. I...