Recent content by roelsl

ok, thanks for all the help! I use Adobe Audition 3.0 and choose my usb codec as the default interface in that software there obviously, but even if I ignore the windows volume control I have the pretty high noise floor (-55 db) coming from the usb thing as well, even if I unplug every source...

Hi all, Thanks for the reply. I'm not talking about my levels on the usb interface itself (the ART Dual Pre). I am talking about setting the levels in Windows, similar like the picture below. I set the level to 20 (our of 100 I guess). Ignore the 70 setting, that;s just a picture i found online...

ok, quick general question. At what level do you set your USB Audio Codec in Windows settings usually? My chain: MIC -> ART Usb DualPre -> WIndows laptop In my Control Panel - Audio settings - Recording devices, I select the USB codec as default and set the levels to 20/100.If I go higher...

battery or not, no difference Ok, as you said, I recorded two session, one with my laptop in the power plug and another just running on batteries. No difference at all ... I do everything right, I suppose? Just connect the interface with USB cable. make sure it is my input source for...

Hi all, I checked 3 A/D USB Interfaces today, all without a mic connected, so just the interface alone. My ATR I mentioned earlier gives me around -55 db noise floor. A Numark interface gave -51 db and the T.Bone (cigar style device) gave me -55 db. Way too much noise coming in as far as I'm...

Ok ... so any idea of a digital interface with a really low noise floor and in the $150 to $200 range? Thanks

Ok, how about 32bit float , what I am doing now. Adobe does not allow me to select 24 bit...

Good question, I'll check that for you ...

Hi Bristol Posse, That -55 dBFS is an average of several minutes, always there. I plug in my usb interface and get a short peak and then I get a constant incoming signal around -55 dbfs. When I record my voice, it peaks at around - 6 dbfs. I come out of the studio, unplug my mic, watch the...

Hi to you all, I am starting as a voice over and have a question about noise floor. My setup: Neumann TLM 102 > ART USB Dual Pre Interface > WIndows Laptop > Adobe Audition 3 When I unplug the mic and just connect the usb interface alone (without any signal coming in to it) I have a noise...