Recent content by horsegrip

Thanks. It took me a while to gain access to TascamForums, but now I have. I'll try my luck there

Hi guys, I finally setup my studio again, after 6 years hiatus. So things are rusty So I have a DM3200, Cubase and Virus I'm wanting to route the Ti USB outputs through the DM. ( pics below) I'm wondering how people have done this. I'm not quite sure on the input selection on the DM. I have a...

Did you sell it on eBay?:laughings: To Bugzee, Is the project a new one, or is it one that was loaded from eBay prior to your purchase? Maybe, try creating a clean project. Also, please explain the rising in volume a bit better. Does any faders under any layer move during the rise in volume? In...

No news from Tascam? I have found them to be pathetic for technical/troubleshooting. I have given up on my previous questions to them. Love the machine, would love their input

I too have a somewhat similar problem. But my DM3200 MU-1000, runs ok unless it's a looped section. Where it stumbles a bit until it catches up. Pretty annoying, given the bandwidth provided for the MU-1000 from the USB. What has Tascam said about this?

In Cubase, open device setup under devices tab (me thinks) Under MIDI device setup, check all 4800 midi ports and make sure you check them as visible too. You should now be able to follow what we have discussed earlier to set it up Here's a pic to show you

Yep, got me there Sorry I was talking about the Lexicon MX400 multi effects rack unit. Cheers

Why isn't there?

Try using my settings for your DM. I've attached some pics

Have you placed the settings in yet? Are you getting any timecode?

Hi Denlig, try these settings on the DM: Under Digital/Timecode page, select MTC (USB) as your "Sync Source" in Steinberg: Under the Transport/Project synchronisation page, select MTC Port for your MIDI timecode and MIDI Clock Out. Let me know how this goes and hopefully we can solve the loop...

Hi Denlig, I have the timecode working, with some minor issues to iron out as stated above. I'm away from my desk atm, but will get back to you with my settings in a day or two. Hold tight. horsegrip

Have you got the card-installed? And locked in you Digital Page. It'll whether the card it locked and therefore you can run tests on it. If the don't work, a combination of DM and Mk2 cards updated, should provided a steady locked card in system

any ideas to this guys?

Ok, I worked the setting problem out. Now, in a final question to the setup. The time code is running, but when I have selected a loop section, the timer runs past the end loop and continues. It doesn't restart at the loop markers. The transport reads correct, but not the meter-bridge. Are there...