Saw these for sale on ebay. Does anyone have any knowledge of this type of tape ? I didn't see any info on it in the sticky shed post. Just wondering if it's for audio use. I guess if it's 3600' reels then it's probably thinner then say 456 ? Thanks. Dave
Has anyone purchased any 406 pancakes from Reel Deal pro audio ? If so do you know the date of manufacture ? I have emailed them but haven't gotten a response yet. Thanks, Dave
I have never seen anything like this before !! I thought I had seen just about everything Tascam Has ever made but this is pretty cool looking, especially with the over bridge. Wonder if my MS16 would fit and this would be strong enough ???
Check it...
Hello Everyone,
Came across an MS-16 on ebay. Something doesn't look right to me on the attached pic of the headstack. Notice the shaft between the left most tape guide and the left lifter. I might be loosing it but I dont think my MS-16 has that shaft ?? From left on my machine I have the...
Hi Everyone,
If some of you ms16 owners out there could lend me a little assist I would greatly appreciate it.
In the maintenance manual on page 7-11 (section 7-5-4. tape tension servo) The diagram shows four different positions (a, b, c and d) To me the "c" position appears to be...
Recently there has been a lot of posts on various recording forums in regard to RMGI tape with shedding problems. I thought my recent experience would be good info to pass along so here goes.
Back in February I acquired a well used Tascam MS16 and after a lot of re-furb work (cleaning...
I recently purchased an ms-16 and I will be going to pick it up in a couple of days. Can someone tell me how involved is it to dismantle for moving ? Basically I would at least like to remove the transport from the tascam stand its in to make it easier to move. The stand has some orange knobs on...
Have you ever seen an MS16 configured this way with the meter bridge above the transport ? Looks pretty cool, Perhaps someone just did a customize job on this one ? When you are doing calibration on the channel cards where are they physically located ? Is access easy ? Thanks in advance, I been...