Behringer Xenyx 502 Audio Overlap Issue

Sorry, it is different from other mixers of the family...
I have an old Xenix 1202 in the closet, then I looked at it thinking that the 502 has only less inputs, but I didn't remember it is more a preamp than a mixer! :-)
Then, the answer is simple: Dear Duck, you need a different mixer... :-(
 
Ya, it was Behringer that convinced me to go for the old mid-'80s Tascam mixer. I use the Behringer a lot, but forget routing. Most of that is thanks the Tascam Users Manual, which gave me better usage of the Behringer.
 
The good of the 1202 is that it's very compact. For this reason, although I have a Spirit Folio F1, I have modded the 1202 adding:
- a PRE/POST switch for the FX send (singers need a PRE aux)
- a phones pre/post main fader (for listening mixer out with the fader closed or at a very low level)

and modifying:
- tape out for a fixed level, before the main fader (for a recording independent of main fader level)
- clip indicators for pre/post channel gain clipping detection (above 0dB position distortion could occur after the channel gain, without warning).
 
You must log in or register to reply here.
Back
Top