TASCAM 464 to Logic Pro: mix and bounce to tape again

1981Recording

New member
Hi all,

I've recorded drums on all four tracks of my TASCAM 464, Glyn Jons setup, and can successfully bounce each track to its own independent track in Logic. I then EQ it and throw on a little reverb and compression. I'm going to bounce all four drum tracks back to one channel on cassette, then record the bass, guitar, vocals, etc. I'm obviously no master of recording or engineering and have a question for you all.

I've been playing my whole life and played dynamically enough throughout each take. But, there are a few spots that could be a little louder or a little quieter. Any advice on adjusting the volume before bouncing it back to one track on cassette or do it when I bounce all instruments to logic?

Thanks in advance for your constructive feedback!
 
Last edited:
Back
Top