Ricklh
New member
I have a stereo looper and Behringer 802 mixer. I have been recording on the looper using the mixer to monitor but when I record a new guitar part, I notice the looper re-records the existing loop that I previously recorded, which results in the drums sounding a little phasey. So I want to be able to record new loops via the mixer but not re-record the existing loop when I'm recording a new track. Anyone else doing this? The mixer has in and out RCA cd/tape connections so I'm wondering if the "CD/tape to control room" button is what I need use? Here's the set-up I'm hoping is correct to achieve what I'm talking about:
1. Guitar to main mixer input (1/4 jack)
2. Looper out to tape input (RCA jacks on mixer)
3. Tape output to looper aux-in
4. CD/tape to control room button engaged
What I was doing before that was different than the above was I was routing the looper out to the main mix, therefore it recorded the existing loop again.
1. Guitar to main mixer input (1/4 jack)
2. Looper out to tape input (RCA jacks on mixer)
3. Tape output to looper aux-in
4. CD/tape to control room button engaged
What I was doing before that was different than the above was I was routing the looper out to the main mix, therefore it recorded the existing loop again.