How do I keep this site from logging me out?, at some point. after spending an hour typing a response!! Only to find most of it gone!
Ron
Ron,
Seems like you have issues elsewhere in the master section.
Do you have a VOM for signal tracing?
Are you getting signal at the CR outs or STUDIO outs or STEREO BUS inserts at the patchbay?
Gary
2 trk inputs on most TASCAM boards without a patch bay just feed to the monitoring section of the board so that you can hear back your recorded stereo masters. But, if they're available on the patch bay, simply patch them over to a standard channel strip if you want to send that signal elsewhere, such as the stereo buss to check if those swapped faders are working properly.
A VOM is just an abbreviation for a meter that reads voltage, amperage and resistance. Volt-Ohm-Meter/ VOM.
Cheers!
Ron,
Didn't realize you had the manual already.
That said,should make this a whole lot easier.
How's it going with the M600?
I'm missing some pages from my manual (16, 17 and 1-14) was wondering if you could fill me in
Sorry SunkenCity I no longer own the M600.