Tascam M-50 / routing Effects ?

C

charlietracks

New member
Hi guys and girls,

I have a Tascam M-50 mixing desk, nothing special, but I like it.. very transparent.

but I cant figure out, how to route my FX to this thing, it has 8 channels and 8 buss'.

im more used to boards with FX sends/returns. never routed to Aux buss' before.
is it even possible ? I have a rack full of delays, chorus, Compressors, exc.. im just not sure how to patch these in.

this is my first OP, id just like to say thank you, this is a great community. happy to be a member here.

Charlie
 
Hey, Charlie.

Welcome.

Any send-type effects inputs can be connected to the aux 1~4 output jacks in the master section. You can connect the outputs of the effects units to any free line inputs on your channel strips. There are other options but let's start there.

Generally you would set the aux sends on each channel strip to POST fader.

Now...tell me what doesn't make sense with the above and we'll go from there.
 
hey sorry for the late reply. thank you very much for the reply. im very grateful.
I see now, the Aux's (green knobs) will increase the FX. im just wondering what to do with all these buss' :-)
I have 8 of them, didn't know if I could patch FX right to a bus and send it from there as well.
thanks again sweet
 
You must log in or register to reply here.
Back
Top