How do I use a TC Helicon product as a post processing effects unit?

Krush411

New member
So I just ordered two units.

The original VoiceLive Touch:

Voicelive-Touch_rear.jpg



and for my interface, the Tascam UH-7000:

uh-7000_p_rear.jpg


Previously I asked how I would connect something similar for live tracking.

Now my question is, how do I set these two up/connect the Touch as a POST PROCESSING effects unit?

So if I record a dry take in my DAW, I want to have that dry vocal go to the Touch to have the effects on it after the vocal has been recorded.

Please advise. Thanks!
 
I think you need a DI box that went from Line Level TRS output to Mic input. That's the only way to get a signal into the TC Helicon box cleanly. I'm not sure if such a box exists and if it did, it would be expensive.

A better bet is to find a VST plug that can do the same thing. Use your TC box for live use only.
 
Not sure I understand the situation!
But, the VLT only puts out up to +14.5dBu, about 4 volts rms and there are many DIs that have attenuators to allow vastly higher input than that.
They will of course be unbalanced in but that won't matter diddly.

Dave.
 
Back
Top