BlaineBird
New member
Does anyone have at least a rough understanding on how to map the transport buttons in FL Studio?I can't seem to find anything explaining how to do this in FL Studio..Any advice is appreciated!
Samson Graphite 49 (Mapping)
- Thread starter BlaineBird
- Start date
ssscientist
Info you can use...
First, if you haven't already, d/l the manual and the sofware update from Samson HERE.
Then go into 'change' mode - or whatever Samson calls it - and try setting the stop key to cc 158 and the play key to cc 159. These are the Midi Machine Control (MMC) numbers. If those work in FL Studio, the rest are on page 30. Good luck and post again w/your success or failure.
Then go into 'change' mode - or whatever Samson calls it - and try setting the stop key to cc 158 and the play key to cc 159. These are the Midi Machine Control (MMC) numbers. If those work in FL Studio, the rest are on page 30. Good luck and post again w/your success or failure.
Hey I figured this out, so I thought of registering and helping you out..
1. "Setup" button on the keyboard
2. Hit the Play button
3. Put these values in:
Port -, Ch -, Type C, Mode M, Value 160
4. Hit enter
and the play button should work
Values for the buttons:
Rewind: 163
Forward: 162
Stop: 159
Play: 160
Record: 164
Hope this works for you!
1. "Setup" button on the keyboard
2. Hit the Play button
3. Put these values in:
Port -, Ch -, Type C, Mode M, Value 160
4. Hit enter
and the play button should work
Values for the buttons:
Rewind: 163
Forward: 162
Stop: 159
Play: 160
Record: 164
Hope this works for you!
BlaineBird
New member
Sorry it took me so long to get back to this but thank all of you because it now WORKS!!!! Much appreciated guys 