T.Bone SC400

JoãoVieira

JoãoVieira

New member
Hi there, i recently screwed up my mic, glueing a plastic thing that holds the diaphragm, i unintentionally disconnected the two wires that come from it (a red and a blue wire that start at the diaphragm and are weld in the wiring board below).
Could anyone please send me a photo of the mic without the external metal case? No need to dismount the upper part of the case, the dust protector, i just need the wiring board.
Thank you
 
Already tried there, no luck. I've sent an email to them, hope they'll answer it. If they do, perhaps i'll post it here for future fails like mine
 
They should answer you - I hope.

But in the mean time get 5 post in your total post count so YOU can post a picture here of your microphone then we can possibly tell you where the leads are to be resoldered. Shouldn't be that hard to figure out. ;)
 
12trzjd2c

134jbuthg

Here they are. As you can see i remember where was the blue wire, just not the red one.
Waiting while heating the solder ;)
 
Here they are. As you can see i remember where was the blue wire, just not the red one.
Waiting while heating the solder ;)
 

Attachments

  • CAM_0027.jpg
    CAM_0027.jpg
    59.7 KB · Views: 82
  • CAM_0028 edited.jpg
    CAM_0028 edited.jpg
    60.8 KB · Views: 83
You must log in or register to reply here.
Back
Top